Ezi-Jak 3 Ton

• 3-in-1 Ezi-Jak Electric Hydraulic Jack & Air Compressor
• Rattle Gun
• 3.5m 12V power cable
• Battery clamp connector
• Safety hammer
  Gloves
• 2 x fuses
• 4 x wrench sockets: 17mm, 19mm, 21mm, 23mm (check compatibility with your wheel nuts)

Total case weight: ~10 kg

Ezi-Jak Electric Hydraulic Jack & Air Compressor

• Vehicle compatibility: Cars, 4WDs, caravans, horse floats, trailers up to 3 tons
• Lifting height: 155–450 mm
• Safety valve included
• 2-way power supply: 12V vehicle socket or car battery
• Built-in air compressor: 74 cm hose, connectors, 150 PSI gauge
• Safety warning light and built-in LED work light
• Aluminium alloy bottom plate
• Portable case with reflective safety strips
• Case dimensions: 35 x 32 x 17 cm
  

Ezi-Rattle Gun

• 2-way power supply: 12V vehicle socket or car battery
• Max torque: 340 N·m
• 1/2 inch drive
• Loosens tight wheel nuts
• Safety warning light

EASY STEPS TO CHANGE YOUR FLAT TYRE

Placing the Ezi-Jak:

1. Check your vehicle's manual for where to correctly place the Ezijak.
   
2. Make sure your vehicle is on accessory and the hand brake is on (or the motor is running). Place your spare tyre under the vehicle.  Plug the power cable into the cigarette lighter (12v plug) or use the battery clamps on the car battery. 
   
3. Place Ezijak under your vehicle in the correct position. Rotate adjusting screw to get the top of the jack as close to the chassis as possible.
4. Press the Lift Button and once the tyre is off the ground turn off lift button.

Using the Ezirattle Gun

1. Connect the power cable to your Ezirattle Gun, put the correct socket adaptor on. The Rattle Gun will only work once you have it attached to the wheel nuts. Hold your finger on the button and it will spin for a little bit, and then click the wheel nut off.  Make sure your finger stays on the button.
   
2. Remove flat tyre and replace with your spare tyre. Tighten the wheel nuts with the Rattle Gun. Press the switch on the Ezijak to lower your vehicle.
   
3. Tighten the wheel nuts with a wheel brace to make sure they are nice and tight and never lie under a car while it is jacked up.

How to use Air Compressor

1. Plug the power cable into the 12v plug or battery. Pull out the air hose located in the side compartment of the Ezijak.
2. Check your vehicle's manual for the correct tyre pressure.
3. Choose the suitable head to connect to the tyre valve and then turn on the power until you get to your desired air pressure.

How to use the Remote Control Cord

1. Connect the remote – Plug the remote control cord (see Photo 1) into the 12-volt cord that’s connected to your Ezijak.

2. Switch to jack mode – On the Ezijak control panel (see Photo 2), press the Jack switch to turn on jack mode.

3. Activate the jack – Press the Lifting button (▲) on the Ezijak once.

4. Operate with the remote – Use the UP or DOWN buttons on the remote control cord to raise or lower the jack.

Download our Manual